What PE means (lg pe error)
An lg pe error means an LG washer cannot read the water level correctly — the pressure (level) sensor is sending a reading the control cannot trust. Because the washer relies on this sensor to fill and drain accurately, PE stops the cycle until the sensor circuit is checked.
Symptoms to look for
The signs below help confirm you are dealing with this condition rather than a different fault on your LG Washer. You may see one of them or several together, and they can build up gradually or appear suddenly after a power event, a long door opening, or recent service.
- The display shows “PE”
- Filling or draining behaves inconsistently
- The washer over- or under-fills
- The fault appears across different cycles
Common causes
Several different faults can produce these symptoms. Working through the most likely causes in order helps separate a quick, owner-level check from a problem that needs trained service and the correct LG parts.
- Failed level sensor — the pressure sensor reads out of range
- Blocked or kinked sensor hose — the air dome path is restricted
- Wiring fault — the sensor connection is loose or broken
- Control input fault — the board misreads the sensor
Troubleshooting steps you can try
Work through these checks in order before calling for service. Stop wherever you are unsure, or where high-voltage parts, gas, the sealed refrigeration system, or a heat-pump compressor are involved, and hand the rest to a qualified technician.
- Power the washer off at the breaker for several minutes, then restore.
- Note whether filling and draining behave abnormally with the code.
- Avoid running heavy cycles while PE is active.
- If PE persists, leave it for service to test the sensor circuit.
Parts a technician may replace
Depending on what the diagnosis shows, a technician may inspect, test, or replace the water level pressure sensor, sensor hose/air dome, wiring, and control board. The correct part for your LG Washer is matched from the model and serial number, and genuine LG components are fitted rather than generic substitutes so that performance, safety, and the appliance’s long working life are all protected. Confirming the failed part before ordering avoids replacing more than the fault actually requires.
When to call a technician
PE needs a technician to test the water-level pressure sensor, its hose, and wiring and replace the failed part. When the fix calls for trained service, book a visit through our scheduling page and an experienced, qualified technician will diagnose and repair it. For manufacturer documentation and model lookup, see the manufacturer at lg.com/us.
Prevention and care
Regular care keeps this condition from returning on your LG Washer. Keep filters, vents, and the condenser or exhaust path clean, avoid overloading or blocking airflow, check that doors and seals close cleanly, and follow the LG maintenance guidance for your model. Because this unit relies on electronic control, protect it with a stable, correctly rated power supply and have any built-in or laundry installation done to LG specification so the control never sees an out-of-range condition. If a code appears, note exactly what was shown before you reset the appliance — that record helps the technician reach an accurate diagnosis and avoid replacing parts unnecessarily.
Related help and LG resources
Browse other LG Washer diagnostics, read about professional LG Washer repair, look up your unit in the LG models reference, or the related FE overfill error, or schedule a service visit. For LG manufacturer documentation and model lookup, visit the manufacturer at lg.com/us.
